Arm-electronics CMS Manuel d'utilisateur télécharger pdf (Page 95)

User’s Manual

7.17 Dome Setting / Dome Control

Userss can also set/control the dome camera in CMS. Right click on the

channel where a dome camera is properly installed. Refer to the following

picture to see how they look like.

Dome Setting:

Select <Dome Setting> to setup the Dome ID or Dome Protocol. Note that

dome protocol changed at this interface is only temporary. To permanently

change dome protocol, please modify it in the configuration.

Dome Control:

The function of each button on the <Dome Control> panel is described below.

A.F. (Auto Focus)

Click on to focus the camera automatically.

Set/Go Preset Point

Click on to set a present point, and to go to the preset point.

Click on to setup the Dome ID/Protocol. This function resembles to the

<Dome Setting>.

Focus

This is used to manually focus on the objects. Click on the <Focus Near> /

<Focus Far> icons to adjust the focus.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 121 122

Pas de commentaire

Arm-electronics CMS Manuel d'utilisateur Page 95